Power Supply Testing/Tutorial to drill holes on the power supply shield

1. Remove the power supply shield

2. Put the power supply shield on the vise grip

3. Get a cup of oil.

4. Put a small drill bit in the drill. Adjust it so that is tight. Dip it in the cup of oil.

5. Start drilling until one makes a hole.

6. Change the drill bit. Increase the size. Dip it in oil

7. Start drilling a bigger hole.

8. Change the drill bit. Increase the size. Dip it in oil

9. Start drilling bigger hole than previous one.

10. Change the drill bit. Increase the size. Dip it in oil

11. Make the last hole (the hole should be as big to fit the bin post)

12. Put the bin post

13. Repeat steps 4-12 four more times to make the five holes.