Clean build plate, and new tapePeal back first edgestick the exposed edge to the build plate, and fold the backing under Pull on the backing to the tape, and allow the tape to transfer smoothly onto the build plate. Easier done two handed rather than while holding a cameraFinished aplication. Smooth out all bubbles and admire the beautiful surfaceRemove excess from front and back of plate to allow build plate to fit back into the makerbot. Cut in the grooves of the build plate with an exacto knife or fine flat blade screwdriver. that's what they are there for DO NOT CUT THE BUILD SURFACE!Remove excessFold edges downFin*LEVEL THE BUILD PLATE