Elasticity/Sample final 3

Sample Final Exam Problem 3

edit

Consider the curved beam   and  , loaded by a bending moment   (but no forces) shown in the figure below.

 
Curved beam
  • (a) Using equilibrium and symmetry considerations, write down a stress function for this problem by choosing the appropriate terms from Michell's solution.
  • (b) Find the stress components that correspond to the stress function you have chosen (you do not have to evaluate the constants).
  • (c) Write down the strong form of the boundary conditions for this problem in terms of components of the stress tensor. (You can use your own symbols to represent surface traction distributions that you cannot specify explicitly).
  • (d) Which strong boundary conditions would you have to substitute with weak boundary conditions (in the St. Venant sense) in order to solve this problem. Write down the appropriate weak boundary conditions in terms of components of the stress tensor.

Solution

edit

Consider the equilibrium of a small section of the beam (free-body diagram). It is obvious that any such section will look exactly like the diagram of the whole beam. Thus, the stresses in the beam cannot vary with   and the beam must be axisymmetric.

Therefore, the appropriate stress function for this problem is (from Michell's solution)

 

The stress components corresponding to this stress function are

 
 
 

At  ,   and  .\

Therefore,

 

At  ,   and  .

Therefore,

 

At  ,   and  , where   and   are unknown traction distributions that correspond to the applied moments.

Therefore,

 

At  ,   and  .

 

Therefore, the strong boundary conditions for this problem are

 
 

In setting up the weak forms of the boundary conditions, we have to set the average tractions over the boundaries   and   to zero and the moment due to the traction distribution to  , i.e.,

 

The traction   acts in the direction of   and goes not generate any moments.

Therefore, the weak forms of the traction BCs are