Beat (acoustics)/Phase beats

Beat (acoustics)   /Phase beats   /Literature search   /Just fifth displace stretch   /Exact phase beats   /Differential equations   subpages   drafts  


There are two kinds of beat patterns when a pair of musical notes is slightly out of tune:

See also WikiJournal Preprints/Phase periodicity and the mystery of musical consonance

Graphing three detuned just intervals

edit

Each graph consists of an upper part that shows the sum of the two signals that are tuned to a just interval, with the lower frequency shifted from 200 Hz to 200.5. This corresponds to a detuning of about 4.32 cents, which the trained ear should recognize as a small deviation from just intonation.[1] Also shown are two associated pure sine waves below on a different axis. The cosine was selected because it is an even function WRT time. This makes the peak associated with cos(0)=0 easy to identify as an important landmark on the plot.

  • The top of each of three images shown below displays integers (1,2,3...). They mark time in units of the quasi-period,  
  • The graph centered on the axis (y=0) is the sum of two cosine wave. The reader can verify that it is "quasi-periodic" with period  .
  • The two cosine waves that were added are superimposed in the space below the horizontal axis. Note that all three signals are even functions with respect to  .
  • In addition to the reddish purple vertical lines that mark quasi-periods, two sky blue[2] vertical lines mark a single beat period that starts at   and  .
  • One of the integers that define the just interval is even for both the fifth, as well as for the minor sixth. Consequently, the sum of the  -wave and  -wave at   is exactly the same at times,   and  , except for an inversion about the y axis. If humans cannot distinguish a sound wave from its additive inverse, then the beat period for fifth and sixth is half that given by the formula introduced above.
  • Sky blue triangles at the bottom of each of the three graphs identify the location of   (and   where appropriate.)
  • The bottom of each image marks of time (in seconds) as  .

Use the slider underneath image to see the entire length of the plot
Beat pattern for a 3/2 fifth that is off by 4.32 cents.   is the beat period.
Beat pattern for a 8/5 minor sixth that is off by 4.32 cents.   is the beat period.[3]
Beat pattern for a 7/5 tritone that is off by 4.32 cents.   is the beat period.[3]

Proof of formula

edit

A different sort of beat occurs between sinusoidal waves at frequencies,  , and,  . We shall define this beat frequency to be   in order to distinguish it from  , due to traditional beating between lowest matching harmonics of two signals. We shall find that  , though two comments are worth keeping in mind:

  1. These "phase cycles" are not likely to involve fluctuations power delivered to a person's ears.[4] They are merely a periodic variation in the shape of the waveform associated caused by the sum of sinusoidal waves whose frequencies differ by the ratio of   to  .
  2. To the best of my knowledge, "phase cycles" have not been established to be responsible for the beats one hears when a musical interval deviates slightly from just intonation.
Fundamental frequencies
edit
 
Characteristic Frequencies Figure
Table 1
 
 
 
     
     
 
 
 
Phase Shift Figure: Shifting one signal in an exactly tuned just interval by a time-shift of   will preserve   as the periodicity of the sum of the two signals.

We adopt the usual symbols for frequency and period,  , with  . Figures 4 and 5 define the relevant frequencies and periods shown in Table 1. In all cases, the pitches are assumed to be exactly tuned to a just interval. Figure 4 illustrates how the shortest time interval,   can be used to express the periods of the two notes that define the interval as: and   and  . We see from this figure that   is the periodicity of the wave created when the p-wave and the q-wave are combined.


Figure 5 illustrates the consequence of shifting one of the waves in time by  . Suppose the origin,   is situated at the left end of the graph. Both waves evaluate to zero at the origin, establishing that they are of the form,  . Both wave have essentially the same relationship with each other after this time shift, except that the alignment between the two sine waves has moved to a new location. A person listening to this interval would perceive this tone to be exactly the same, whether it was shifted or unshifted. This fact will be used to establish the beat frequency formula for  .

It is important to understand that in this context,   is not being used to label harmonic overtones because a pure sine wave has no overtones. In contrast to the situation with amplitude beats, the index   is simply used to describe the frequency at which phase beats can be heard.

Thus far, the discussion has focused on two pure tones.[5] The motive for time-shifting one signal in Figure 5 will be explained in the next section to reveal how our formula for our ( ) formula for   was obtained. The need for the ( ) for   was discovered accidently after the alignment of the   and   waves at   in Figure 1 was noticed.

Stretching a long rubber band

edit

This section is under construction

 
For a just fifth,  . Waveform E is exactly in tune, and D is also exact but with the p-wave displaced. The S-wave is detuned by stretching the p-wave by   If each of the colored squares represent one unit of time,       and   The time duration of the E-wave is   The observed   beat frequency is the time between   and  
 
 
 
This verifies the postulate regarding the existence of   for   6/5, 5/4, 4/3, 7/5, 3/2, 10/7, 8/5, 5/3, labeled under the convention that the pitch of A4 is lower than th7e pitch of d5. [6]

Figure 6 (to the right) examines the consequence of time-shifting one of the two signals in an exactly tuned interval by a small time-interval. It also shows how this shift can be used to understand what happens if one of the pitches is slightly detuned. The formula for phase beats is best understood by first thinking about a long rubber band. If you are holding both ends of a rubber band with your hands, there are two ways to move the rubber band to your right:

  1. You can displace (D) the rubber band by moving both hands in the same direction.

  2. You can stretch (S) the rubber band by moving only your right hand.

Suppose the rubber band is 100 cm long and you stretch it by 0.1 cm. You can measure that distance with a ruler. But an ant standing on the rubber band would observe a much smaller local displacement, since 1 cm would stretch to only 1.001 cm. She would need an ant-size ruler! The story of the ant and the rubber band explains the connection between displacing the waveform with a phase shift and stretching the waveform by reducing its frequency. Figure 7 illustrates how a stretch is distributed along the entire length of a rod.

GARBLED PARAGRAPH... llustrates a rubber with an initial length of   Suppose you stretch it to a new length,

     ,

where   is .25 meters. Now imagine you can get so small that you can get inside and look at the "atoms". How much would each "atom" stretch? Answer: Each "atom" would stretch by the same factor that the entire rubber band is stretched. This factor is what material scientists call strain:

     

where   is the rubber band's length and   is the size of what we are loosely calling the "atom". It is nearly impossible for conventional atoms to stretch with this much strain. A rubber band's "atoms" are actually polymer chains. The effective length of the polymer chain depicted in Figure ? is R. Stretching the rubber band just straightens out the polymer chain.

In this discussion, the horizontal axis is not distance (x), but time (t). For our purposes, the analog to length,   is period,  . Our formula for phase beats is only an approximation based on the assumption that  , where one or both pitches are detuned by  . In this approximation, we may use the following formula relating small changes in frequency or period:

 

This is easy to prove using calculus, but here we avoid calculus with three examples, letting   and   yields:

     

For our purposes, a typical value of   is 0.01, which corresponds to 1%. But we need to avoid the percent symbol because music uses a different measure of small fractions called "cents". The difference between any two adjacent keys on a piano (e.g. G♯/G) ratio 1.0594, or about a 6% difference. But this difference is called "100 cents" (or 100¢.). The barely perceptible error in the piano's equal tempered perfect fifth is flat by about 2¢, while equal tempered major third is sharp by about 15¢. Acoustical beats on musical instruments are easier to hear the just interval is detuned by less than 10¢, which means the piano's octave, fourth, and fifth are the best places to hear beats. On most pianos, a single note that has two strings is often the best place to look.

under construction

edit

[7] To construct this plausibility argument, we replace the integer   of the higher frequency by a slightly smaller number,   that is not an integer. This will stretch the figure by a factor of approximately  .

Recall that the Phase Shift Figure (above) informs us that time-shifting the signal by  , which is the smallest of our timescales. The new location of   is not a serious problem because if one is very close to just intonation, the beat time is much larger than  . Listeners will not likely notice by a beat that is early or late by such a small time interval. Defining,  , as the beat period, we shall always work in the approximation that:

 

Consider a single beat with periodicity   that consists of many short segments of length  . Our goal is to gently "stretch" the  -wave so its length is increased from   to  :

 


  .

The LHS of this equation represents the fact that we have increased the p-wavetrains length (in time) by decreasing the frequency (and hence increasing its period,   by a the small time interval  . The RHS represents the fact that we must enhance the length of the  -wave by   to create the new beat illustrated in the Phase Shift Figure. Since the length of the  -wavetrain was   before we "stretched' the period  , we have:

  

Since   was chosen to "stretch" the  -wavetrain by an amount equal to  we have:

  ,

which yields:

GARBLED PARAGRAPH


The last step used,  , which can be verified from Table 1. After some thought,[8]For example, if the just interval was exactly tuned before raising an equal number of cents, it the exact intonation of the interval is preserved. It would take a 100 cent shift to change   by 6%[9] It can be shown[10] that:

   

The prescript 1 was added to this beat frequency because there is another beat frequency,  . It is associated with the time interval   shown in figure ?, where   is similar not to  , but to its additive inverse. It seems likely that the human ear would perceive   and   as having the same or nearly the same timbre. Figure ? shows that investigation of beats at this new frequency is performed by replacing   by  . Shifting time by   reveals the longer of the two phase beat periods,  , while stretching by half that amount reveals the shorter value of  .

Doubling the beat frequency when p or q is even

edit

This will be explained elsewhere.


Fourier analysis

edit
Not yet needed

See also w:Kramers–Kronig relations, w:Cauchy principal value, [1]and w:Sokhotski–Plemelj theorem

 

 

 

 

Hearing the beats

edit
Needs verification that these are i=1 beats.
interval Frequencies ogg file wav file   cents
Fifth 300.0-200.25
Maj 6th 333.333-200.3
Fourth 266.667-200.188
Maj 3rd 250.0-200.15
min 6th 320.0-200.094
min 3rd 240.0-200.125
Tritone 280.0-200.214
edit
Essential reading
  • Shapira Lots, Inbal, and Lewi Stone. "Perception of musical consonance and dissonance: an outcome of neural synchronization." Journal of the Royal Society Interface 5.29 (2008): 1429-1434. Available as pdf and HTML
Basic
Advanced or different
Algebra and/or failed efforts

Beat (acoustics)


  1. In contrast with the graph's 4.3 cent deviation, the equal temperament's major third is off by 13.7 cents.
  2. See c:Commons:Creating accessible illustrations
  3. 3.0 3.1 Since the frequency ratio involves an even number, the actual beat period might be half this amount, or  .
  4. Some fluctuation in power is possible if the two frequencies are sufficiently far apart. A careful reading of most physics books reveals that calculations of a wave's power focuses on the time-averaged passage of energy through a reference plane.
  5. A "pure tone" is a sine or cosine wave, i.e., a wave with no overtones.
  6. A 2-1 "vote" by the WMF supports this convention. See c:File:Music_intervals_frequency_ratio_equal_tempered_pythagorean_comparison.svg, w:Special:Permalink/1135549750#Main_intervals, and w:Special:Permalink/1134130904#Size_in_different_tuning_systems
  7. The advantage in dealing with only intensive parameters is that equations seem more obvious: As you include factors in an expression, you know you are wrong if both sides are not intensive. A thread or thin string cannot be used to measure something that is a few meters long because even though a short segment might seem stiff, a long segment is so springy it doesn't seem to have a well-defined "length". See also these Washington University notes.
  8. The "thought" is more of a long story than rigorous logic: I know that raising two notes in an interval by the same number of cents will preserves the essential nature of the interval.
  9. Also, it is clear that this is the correct formula of the q-frequency is instead varied (keeping the p-frequency constant.) Hence, we know this formula is correct for three special cases.
  10. ...another student project
  11. Weinberger, Norman (September 2006). "Music And The Brain". Scientific American 16 (3): 36-43. doi:10.1038/scientificamerican0906-36sp. https://www.scientificamerican.com/article/music-and-the-brain-2006-09/. Retrieved 2022-08-04. 
  12. Note the inserted footnote templates regarding "verification" and "original research?" at w:special:permalink/1102305761.
  13. Let  , and take the derivative to get,  , which leads to: