Arduino/Junk pile steeper motor survey

The purpose of this page is to record the wiring of junked stepper motors to arduino motor shields.

Stepper motors have 4 or more wires going into them. Not all motors with 4 or more wires are stepper motors. Typically these motors do not settle down and display a constant ohm value. Instead the resistance reading go to zero or infinity. Switching the polarity of the probes measuring resistance causes different resistance values.

Next Steps

• Attach motor shield to larger power source .. 9-12volts .. perhaps up to 1.5amps. See how motor strength improves and how chips on motor shield heat up.
• Get spark fun motor shields working .. suppose to handle more power
• Count teeth on the gears to see if there are standards that can be leveraged
• Research PC power supply specifications to see if they are going to be useful
• Figure out how fast the motors can rotate .. some seem pretty slow .. this may be due to the stepper motor program or sketch.

Individual Motor Details

Pairs	Motor Description	Motor Thumb
orange/blue, purple/red	4 wire 10 ohm Colored solid wires were attached Mitsumi M355SP-9T C6747-60005 B2703
orange/yellow, brown/black	4 wire 12 ohm Mitsumi M42SP-5 24 Volt 7.5 degree step RH7-1197 TC5X07
brown/red, white/green black ground	5 wire 75 ohm ASTROSYN Minebea Tandon 17PS-C007-04 966000-001
yellow/orange, green/gray brown ground	5 wire 15 ohm NMB Mineba Electronics PM55L-048-HP69 C2164-60045 TC1Z72C
blue/yellow, gray/purple all red and black tied together for ground	8 wire 42 ohm Colored solid wires were attached 990411206001 MB 11 0579
black/brown, yellow/orange red wires both to ground	6 wire 40 ohm ASTROSYN 17BB-H255-03 12V 0.3A T8207 4 phase 07AA8003
black/blue, orange/yellow white wires both to ground	6 wire 50 ohm ASTROSYN 23BB-H028-12 24 volt 4 phase 54485376
orange/yellow, brown/black	4 wire 13 ohm no markings on it
orange/yellow, brown/black	4 wire Mitsumi M49SP-3K LF L6HAYYYK0025

Arduino